I am a person of practicality and utility. This is important because the Waterfall Bong really holds no other advantages over any other bong, accept for being "cool". However, I?m bullheaded so I will attempt to defend the waterfall bong. In essence one can save their breath sucking smoke into a chamber, and also one can accurately incinerate a given amount of Marijuana, therefor controlling the dose.

The Ingredients:

1. 2 [or 3] liter soda bottle

2. Aluminum foil or a removable bowl and/or slide

3. Cigarette (Or any device for making a hole in the bottle)

4. Safety pin, Needle, etc.

5. Kitchen Sink, Bathtub, etc.

6. Water

The Manufacturing Process:

1. Remove the cap from the bottle. If you have a removable bowl from another bong you may attempt to drill a hole in the center of the cap and fit the bowl. If you?re lazy or just don?t have a removable bowl you?ll need the oh-so popular aluminum foil. Toss the cap and wrap a piece of aluminum foil around the top of the bottle, acting as a new cap. The aluminum foil should dip slightly into the bottle forming a "bowl". This bowl should be able to be taken off and replaced easily. If you?ve gone with the removable bowl/cap combo then you?re set, just screw on and off.

2. Using a safety pin or needle poke several holes in a bullseye pattern around your foil bowl.

3. Using a cigarette or cutting device of choice make a hole (about the diameter of a cigarette) near the bottom of the bottle. If you didn?t figure out how to use the cigarette, light the fuckin? thing and press it against the side of the bottle until the cigarette burns through.

4. Remove the bowl from the top and holding your finger over the hole, fill the bottle with water up to the neck, inches below where the bowl will dip.

5. Replace bowl and put the given amount of dope on/in the bowl (Note: all the Marijuana will be used in a single use, so I?d pack lightly).

6. Holding the bottle over a sink, light the lighter and bring the flame towards the pot while at the same time taking your finger from the hole.

The water will rush from the hole, and suck the Marijuana smoke into the bottle to fill the void. It may be necessary to light the bowl a couple times as the water continues to stream out. However, it often only needs one light. After the water above the hole has been completely drained, remove the bowl from the top, place mouth over the top and suck in the smoke, using the hole at the bottom as a shotgun.